Call Now
ProFix Appliance Repair van and technician in downtown Columbus, Ohio

Dishwasher · Appliance checklist

Monthly Dishwasher Checklist for Cleaner Dishes

Clean the filter, spray arms and door seal, check the drain and handle hard water scale. A monthly dishwasher checklist for cleaner dishes and fewer leaks.

By Columbus ProFix Repair4 min read

If your dishwasher has started leaving a gritty film on glasses or a smell when you open the door, the cause is very often a dirty filter. Many dishwashers made in the last decade or so use a manual filter that the owner is supposed to clean, and a lot of people don't know it's there. Cleaning it takes a few minutes. Here is a monthly routine that covers the filter and the handful of other things that keep a dishwasher working well.

Monthly tasks

Clean the filter

Pull out the bottom rack. Most filters sit in the floor of the tub, under the lower spray arm, and twist out with a quarter turn. Rinse the cylindrical filter and the flat mesh screen under warm running water, using a soft brush for stubborn debris. Don't use a wire brush, which can tear the mesh. Reinstall it firmly; a loose filter lets debris into the pump.

Check the spray arms

Spin each arm by hand; it should turn freely. Look at the small holes for seeds, bits of glass or mineral deposits, and clear them with a toothpick. Many arms come off with a gentle twist or a clip for rinsing.

Wipe the door seal and edges

Food and grime collect along the bottom of the door and the gasket, outside the reach of the spray. Wipe them with a damp cloth and mild cleaner.

Check the drain area

Look for standing water in the bottom of the tub after a cycle. A small amount in some models is normal; more than that suggests a clogged filter, drain hose or disposal connection.

Run a cleaning cycle

Use a dishwasher cleaner as directed, on a hot cycle with the tub empty.

Troubleshooting at a glance

SymptomTry firstIf it continues
Dishes still dirtyClean filter and spray arms; don't block arms with tall itemsWash pump or water inlet issue
White film or spotsUse rinse aid; try a citric acid cleanerCheck water hardness setting if the model has one
Water left in the bottomClean filter; run disposal; check drain hose for kinksDrain pump or check valve
Bad smellClean filter and door edges; run a cleaning cycleDrain loop or air gap problem
Leaking at the doorCheck seal, level and overuse of detergentDoor gasket or latch replacement
Not dryingUse rinse aid; open the door after the cycleHeating element or vent fan

The hard water factor

Even softened City of Columbus water carries some minerals, and well water in rural parts of Central Ohio can carry much more. Minerals leave white film on glassware, build up on spray arm holes and coat the heating element over time. Rinse aid helps water sheet off dishes. Some dishwashers, particularly European brands, have a built-in softener with a salt reservoir and a hardness setting; check your manual and set it for your water. If you're on a well with iron, rust-colored stains inside the tub are a sign the water itself needs treatment.

Loading habits that help

  • Scrape food into the trash, but don't pre-rinse heavily. Modern detergents work best with some soil to act on.
  • Face dirty surfaces toward the spray, and keep large items from blocking the detergent door.
  • Run the kitchen faucet until the water is hot before starting the cycle, so the dishwasher fills with hot water.
  • Run the disposal before starting if the dishwasher drains through it.
  • Use the detergent your manufacturer recommends and don't use hand dish soap, which can flood the kitchen with suds.

Under the sink, twice a year

Open the sink cabinet and look at the dishwasher's water supply and drain hose. Check for drips at the connections, a kink in the drain hose, and that the drain hose has a high loop or air gap to prevent dirty sink water from flowing back into the dishwasher. If the cabinet floor is warped or stained, there's been a leak. Also check the floor in front of the dishwasher for soft spots.

Brand notes

Some brands, including Bosch and KitchenAid, have leak sensors that shut the dishwasher down and display a code if water reaches a pan under the tub. If you see that kind of code, check under the sink and in front of the unit before resetting. Repeated leak codes are worth a service call rather than a reset.

When to call for a repair

Get help for a dishwasher that won't drain after you've cleaned the filter, won't start, leaks under the door repeatedly, trips the breaker, or smells like burning. Our dishwasher repair page describes the drain pump, inlet valve and control issues we see most often. In busy family kitchens in suburbs like Pickerington, where the dishwasher runs every day, this monthly routine pays off quickly; our Pickerington area page has more on the area.

Need Help With an Appliance in Central Ohio?

Repairs for most major brands across Columbus and the surrounding counties · Often same-day, depending on the schedule

More From Our Blog

CallBook